Monday, 26 January 2009
  0 Replies
  1.2K Visits
0
Votes
Undo
  Subscribe
Hello, everybody. I'm about to re-cab and would like some quick opinions from other forum members. I need a light-weight 4-10, but I have also considered other configurations. There are no dealers nearby for the cabs I've been looking at, reading about, and going back to: [b:8yvyqt15]Epifani UL series Schroeder Light cabs [/b:8yvyqt15] Your input is valued. Thanks, Mark
12 years ago
·
#12588
0
Votes
Undo
[quote="knuckle_head":58whqtbc]Thanks for the welcome. :) I've been talking way too big to Sheldon for way too long - I hope I can find a way to live up to the hype. I'm the last person he needs to help him with basses. ....no, really. :D[/quote:58whqtbc] 's just a thought. Discuss amongst ya'selves...I'm getting verklempt. :)
12 years ago
·
#12587
0
Votes
Undo
[quote="davio":22zw5281]Good to see you around these parts, Skip! Any plans for some insane-o-crazy collaboration with Sheldon for an 8va down Dingwall? :twisted: :lol: ...and could you make it a Torzal while you're at it? :roll:[/quote:22zw5281] Thanks for the welcome. :) I've been talking way too big to Sheldon for way too long - I hope I can find a way to live up to the hype. I'm the last person he needs to help him with basses. ....no, really. :D
12 years ago
·
#12584
0
Votes
Undo
Good to see you around these parts, Skip! Any plans for some insane-o-crazy collaboration with Sheldon for an 8va down Dingwall? :twisted: :lol: ...and could you make it a Torzal while you're at it? :roll:
12 years ago
·
#12583
0
Votes
Undo
If I may suggest; consider a pair of Bag Ends. The D10B-D and the D10BX-D will give you the highs that the quad 10 will but will give you more low end extension. It becomes modular should you not need both cabs as well. And there is always the Infra to put underneath when you're ready for F#. ;) Edit; oops, too late. Hope you're enjoying your cabs!
12 years ago
·
#12576
0
Votes
Undo
[quote="guitarded":1e35vuam]You'd ask for help and they would say "No". [/quote:1e35vuam] Wow, that's a bunch of BS. I don't think I've ever experienced that attitude from fellow band mates.
12 years ago
·
#12573
0
Votes
Undo
No one has suggested Eden yet so I'll give my biased opinion. :) I use a d210xst 4-ohm cab (2-10s, rated 500w, tuned to 30hz) paired with a wt550 head. I ordered this setup having not heard it, only based on Internet hearsay...it has not disappointed me yet. I've not heard a single bad comment about this amp or my tone. Other players in my church have used it and concur. I went from a 100lb Ampeg 410 to this lighter, more low end, smaller cab. It really speaks clearly even with the low B (drop low A) on my ABII-5. I'm glad I don't need to shop for a rig anymore! I know Eden the company has received some flak lately especially with David N leaving, but I've never had a problem in 4 years of using this rig with various basses (Stingray5, Sterling4, Lakland 55-02, Warwick, Yamaha, Ibanez, Rickenbacker, and Dingwall). The head was even dropped once and it kept on ticking. PS....I've been absent from the forum a long while, lots of real life stuff been going on. It's cool to see the regulars still here (FRB, smallmouth, etc)! I'm still dreaming of my SJ5!
12 years ago
·
#12570
0
Votes
Undo
[quote="BurningSkies":2soa52np]Very fortunate. Its especially hard to get anyone to help AFTER the show It's also why I run with two smaller cabs and a small head. I've also been the one saddled with PA duty for gigs that we need to provide...so you can triple my load times! What I'd really love is having someone in the band who would take interest in knowing how to set up a simple PA and how to run it. The guitarist I play with feigns ignorance so he can avoid having anything to do with it. L.A.Z.Y.[/quote:2soa52np] i've only run into this problem with one member of one band i was in. a singer that wouldn't help carry any gear. she didn't last long. there is no excuse for not helping your fellow band members(and friends hopefully) carry gear unless you have a back problem or something. anything else is basically disrespect in my eyes.
12 years ago
·
#12569
0
Votes
Undo
Very fortunate. Its especially hard to get anyone to help AFTER the show It's also why I run with two smaller cabs and a small head. I've also been the one saddled with PA duty for gigs that we need to provide...so you can triple my load times! What I'd really love is having someone in the band who would take interest in knowing how to set up a simple PA and how to run it. The guitarist I play with feigns ignorance so he can avoid having anything to do with it. L.A.Z.Y.
12 years ago
·
#12568
0
Votes
Undo
my current rig is a peavey 1x18cab sitting under an ampeg 8x10. i have a mesa bass 400+ driving the 18 and an ampeg svt vri driving the ampeg 8x10. i've played mesa boogie road ready 2x15 cabs that pushed a lot of air and sounded really good. i'd give it a 15 and 4x10s and get the best of both worlds. both ampeg in my opinion.
12 years ago
·
#12567
0
Votes
Undo
[quote="guitarded":1hf0hxn4]Nice rig. That's dedication to the craft having to haul a half-ton PJB stack to the gig. I've been looking to lighten my load the past few years. I actually played in a band for a short time where the other guys wouldn't help each other load. You'd ask for help and they would say "No". We played a lot at a place where you couldn't get your car close to the outside stage, only bikes were allowed. Carrying a Hartke 410 XL alone (nearly 90lbs) a few hundred feet across a dirt and gravel parking lot broke my spirit and started me on the quest for a lighter rig (and another band!). Mark[/quote:1hf0hxn4] I'd say your experience is typical. I used to have to "do it all" book the gigs, set up the pa, amps, etc. When it was over I had to tear it all down by myself load it up and unload it in my basement. This is the first band I have ever been in where no one leaves until the last cord is rolled and everything is on the truck, including the stage swept. This is all done without asking, everyone just does it. This is a great bunch of guys, I'm fortunate to be among them.
12 years ago
·
#12566
0
Votes
Undo
Nice rig. That's dedication to the craft having to haul a half-ton PJB stack to the gig. I've been looking to lighten my load the past few years. I actually played in a band for a short time where the other guys wouldn't help each other load. You'd ask for help and they would say "No". We played a lot at a place where you couldn't get your car close to the outside stage, only bikes were allowed. Carrying a Hartke 410 XL alone (nearly 90lbs) a few hundred feet across a dirt and gravel parking lot broke my spirit and started me on the quest for a lighter rig (and another band!). Mark
12 years ago
·
#12565
0
Votes
Undo
I can't help thinking of Daleks (Doctor Who) everytime I see those cabinets, hehehe. EG
12 years ago
·
#12548
0
Votes
Undo
[quote="Dragonlord":2lkm778c]If my drummer was as muscular as yours, I wouldn't mind the weight either. Enjoy the new rig![/quote:2lkm778c] Yeah, he's nice to have around to make sure you get paid, if trouble starts, etc. Really one of the nicest guys I've ever met, I don't think he'd hurt a fly. (unless it really made him mad) The rig DOES weigh a ton, I do have a technique down for getting it in and out of my vehicle and house, but if the gig has stairs (as this one did) help is absolutely necessary.
12 years ago
·
#12544
0
Votes
Undo
[quote="Dragonlord":2astlbz1]If my drummer was as muscular as yours, I wouldn't mind the weight either. Enjoy the new rig![/quote:2astlbz1] :D No joke! Those speaker cables are probably a trip to the car all by themselves! Congrats on the purchase! I've played a few PJB products and was impressed but it wasn't my thing. Looks pretty impressive in this large format, though. :)
12 years ago
·
#12542
0
Votes
Undo
If my drummer was as muscular as yours, I wouldn't mind the weight either. Enjoy the new rig!
12 years ago
·
#12536
0
Votes
Undo
Speaking of Gary at Guitar X, I purchased this rig from him. The Phil Jones M-500 head, 8T cab, and 16B cab. I played it at rehearsal and at a gig this week, it blows away my Ampeg SVT-AV head and 810 rig. Many thanks to members like TwoPort and others who freely shared advice about PJB. It was a sight unseen (sound unheard) major purchase, similar to buying a Dingwall, many good reviews, but nothing to get your hands on. I am a happy Dingwall, and now PJB 5 inch driver convert! Oh, yeah, I had to take the cheezy "Pirhana" applique' off the grill. If it had been bugs bunny or the tazmanian devil I would have left it on. [img:1vczms3o]http://i511.photobucket.com/albums/s354/rollerberg2000/Phil%20Jones%20Bass%20030509/100_3859.jpg[/img:1vczms3o] [img:1vczms3o]http://i511.photobucket.com/albums/s354/rollerberg2000/Phil%20Jones%20Bass%20030509/100_3870.jpg[/img:1vczms3o] [img:1vczms3o]http://i511.photobucket.com/albums/s354/rollerberg2000/Phil%20Jones%20Bass%20030509/100_3873.jpg[/img:1vczms3o] [img:1vczms3o]http://i511.photobucket.com/albums/s354/rollerberg2000/Soul%20Driver%20Quaker%20Steak%20and%20Lube%20030609/100_3941.jpg[/img:1vczms3o] [/img]
12 years ago
·
#12407
0
Votes
Undo
I guess I can't really tell you what to get. I use a Line 6 XT Live board fed into a Mackie 800W Power Amp and use a Yorkville 8x8. Sounds great, but I'll probably be adding a Glockenklang Bass Art Preamp soon. Looking for a more natural sound over the Line 6 board. Not to mention, I have a Special Edition Dingwall ABII 5 String from Guitar X coming to me very soon. It'll be awesome!
12 years ago
·
#12402
0
Votes
Undo
I got the Epifani UL2-410 and gigged with it. It's an awesome cabinet. It has a crazy amount of low-end response. So far, I'm very pleased. Mark
12 years ago
·
#12176
0
Votes
Undo
Yes, epifani cabs are ridiculously light, I picked up a 310 and I could have been convinced there are no woofers in it :D Great sounding too, good choice.
12 years ago
·
#12175
0
Votes
Undo
Wow! 57 lbs for 4 10s is quite impressive. I used to have a 2 x 10" cab that weighed more than that!
  • Page :
  • 1
  • 2
There are no replies made for this post yet.
Be one of the first to reply to this post!